Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Mixture adjusting screws.

  1. #11
    Join Date
    Nov 2017
    Posts
    92

    Re: Mixture adjusting screws.

    Carb mixture needs to be set up on the bike with the engine running preferably with a colour tune plug or alternatively by ear. 2 and 1/2 turns out may be a good starting point but mine ran shite until I tried setting to 2 turns out, but will see if I can fine tune while the engine is running if I can find a tool to allow small adjustments on a hot engine.
    The correct Kawasaki tool is the boy for the job but are a f*****ng fortune for a job you will only do once in a blue moon.

  2. #12
    Join Date
    May 2011
    Location
    NORTHUMBERLAND UK
    Posts
    1,189

    Re: Mixture adjusting screws.

    This is what I use / made.
    Screwdriver bit with a clutch cable adjuster and a bit of JB Weld.
    Used it for 20 years on many bikes............but with this ZRX1200R A6F its not possible as the fuel solenoids get in the way !



    Pete
    THE OLDER I GET THE BETTER I WAS...................

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


Green Web Hosting! This site hosted by DreamHost.

Click here to order your ZRXOC Merchandise