Activity Stream

Filter
Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums
  • zrixer's Avatar
    Today, 01:21 PM
    Purge, Firstly, I'm surprised(and pleased!) the board is still running from what I'd heard, did you fit genuine or pattern rad to yours, are the...
    15 replies | 1554 view(s)
  • noggin's Avatar
    Today, 12:29 PM
    noggin replied to a thread AFR Meter in ZRX Technical Q&A
    If the spark plugs aren't too old they may be fine to simply burn the carbon off with a blowtorch/gas hob. 6 months is probably pushing it for...
    14 replies | 225 view(s)
  • izzy10r's Avatar
    Today, 09:30 AM
    izzy10r replied to a thread AFR Meter in ZRX Technical Q&A
    I got the plugs off. They looked pretty black. Couldn't see a spark either. Will gets some new plugs and fuel tomorrow and give it a try.
    14 replies | 225 view(s)
  • nikroc's Avatar
    Today, 08:14 AM
    nikroc replied to a thread AFR Meter in ZRX Technical Q&A
    And change the fuel. I have just had to strip and clean the carbs,on my 12,after letting her stand with what I thought was good petrol. As you have...
    14 replies | 225 view(s)
  • izzy10r's Avatar
    Yesterday, 11:26 PM
    izzy10r replied to a thread AFR Meter in ZRX Technical Q&A
    The bike turns over but did not want to start at all. I primed the carbs, choke on and no throttle. The fuel is about 6 months old. It's high quality...
    14 replies | 225 view(s)
  • ron1's Avatar
    Yesterday, 07:04 PM
    Just fitted some Hagon nitro's and a set of their fork springs to my bike. The shocks went on nice and easy ...but the springs what a twat of a job...
    0 replies | 43 view(s)
  • nikroc's Avatar
    Yesterday, 06:38 PM
    nikroc replied to a thread AFR Meter in ZRX Technical Q&A
    Did it try and start at all?...fresh fuel etc?..take a plug out and ground it ,see if you have a spark.You thought of Easy Start or similar?..
    14 replies | 225 view(s)
  • izzy10r's Avatar
    Yesterday, 10:14 AM
    izzy10r replied to a thread AFR Meter in ZRX Technical Q&A
    Tried firing her up. Battery completely charged. No luck :( Might check the plugs. I did put in new plugs before she went into storage. Not sure if...
    14 replies | 225 view(s)
  • noggin's Avatar
    Yesterday, 10:05 AM
    noggin replied to a thread AFR Meter in ZRX Technical Q&A
    Easy to wire in, nothing special needed except maybe a relay so it's only on with the ignition (if you can wire in a satnav etc then it's as simple...
    14 replies | 225 view(s)
  • Kwaker's Avatar
    3rd June 2020, 08:29 PM
    Hi Chris. Thanks for the photos. I'll pass on it please as I really fancy the squarer look. Hopefully somebody will have it from you. ...
    7 replies | 165 view(s)
  • Chris'ZRX's Avatar
    3rd June 2020, 06:07 PM
    Took it off when I fitted my motech rack. Quite sturdy I think though the paint is peeling in places could easily be tidied up a bit. The front...
    7 replies | 165 view(s)
  • nikroc's Avatar
    3rd June 2020, 12:09 PM
    nikroc replied to a thread AFR Meter in ZRX Technical Q&A
    Try it and see....obv's with a freshly charged battery. Id take plug caps off and turn it over a few times to get the cold oil around all the engine...
    14 replies | 225 view(s)
  • izzy10r's Avatar
    3rd June 2020, 10:25 AM
    izzy10r replied to a thread AFR Meter in ZRX Technical Q&A
    I do have a few bikes so would definitely be worth it. I got mine tuned in 2017, and spent about $700 on it! Don't want to spend that much again. Are...
    14 replies | 225 view(s)
  • noggin's Avatar
    3rd June 2020, 08:57 AM
    noggin replied to a thread AFR Meter in ZRX Technical Q&A
    I disagree - I have an AFR gauge that I've used on a few bikes and a kit car that I had years ago and adapted to run on ZX6R carbs (on a 2.0 Sierra...
    14 replies | 225 view(s)
  • izzy10r's Avatar
    3rd June 2020, 08:49 AM
    izzy10r replied to a thread AFR Meter in ZRX Technical Q&A
    Cheers mate
    14 replies | 225 view(s)
  • Kwaker's Avatar
    3rd June 2020, 06:13 AM
    Hi Chris. Thanks for the reply. Yes I'm interested, any chance of a photo or two? Cheers Gus
    7 replies | 165 view(s)
  • jds's Avatar
    3rd June 2020, 12:54 AM
    jds replied to a thread AFR Meter in ZRX Technical Q&A
    If you place the shim/shims under the clip, this will lift the needle position and richen the mixture. Anything you do is always reversible. Check...
    14 replies | 225 view(s)
  • izzy10r's Avatar
    2nd June 2020, 11:46 PM
    izzy10r replied to a thread AFR Meter in ZRX Technical Q&A
    I did get mine set up on the dyno about a year and a half ago. spent a considerable amount on the setup. I'm currently running a full system, pod...
    14 replies | 225 view(s)
  • jds's Avatar
    2nd June 2020, 07:54 PM
    jds replied to a thread AFR Meter in ZRX Technical Q&A
    . I've got a Morgan Carbtune for carb balancing . Its easy to use and works well, but won't help you with your air/fuel set up. The old school...
    14 replies | 225 view(s)
  • Chris'ZRX's Avatar
    2nd June 2020, 07:10 PM
    I've got a big tubular wrap around grab rail that is a little tatty but usable if you're interested? Thicker tube than on that Renntech rack.
    7 replies | 165 view(s)
  • nikroc's Avatar
    2nd June 2020, 08:10 AM
    Looking good..its inspiring seeing you do this kinda work ...keep em coming..
    25 replies | 600 view(s)
  • izzy10r's Avatar
    2nd June 2020, 12:41 AM
    izzy10r started a thread AFR Meter in ZRX Technical Q&A
    G'day all. Has anyone here used an Air Fuel Ratio Meter/Gauge? I'm planning to play around with some jet options and didn't want to take it into a...
    14 replies | 225 view(s)
  • wild32's Avatar
    1st June 2020, 08:49 PM
    I had one once, I personally found it a bit tall. it’s a long story but it got stolen .
    7 replies | 165 view(s)
  • Kwaker's Avatar
    1st June 2020, 07:24 PM
    Yes Sir. Wife has found renewed interest in going out on the bike and she won't like the side rails. Gus
    7 replies | 165 view(s)
  • wild32's Avatar
    1st June 2020, 05:25 PM
    Are you cutting the back off to make a grab rail?
    7 replies | 165 view(s)
  • Kwaker's Avatar
    1st June 2020, 01:23 PM
    Hello Gents Does anybody have a tatty old Renntec rack they would part with for me to cut up? Many thanks. Gus
    7 replies | 165 view(s)
  • z1baz's Avatar
    31st May 2020, 11:53 PM
    z1baz replied to a thread 1100 sump wanted in Wanted
    cant helicoil it will ?
    1 replies | 147 view(s)
More Activity


Green Web Hosting! This site hosted by DreamHost.

Click here to order your ZRXOC Merchandise